User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Manage Switch Security User Manual598
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Security > Control > Captive Portal > CP T
rap Flags.
5. Select the CP
Trap Mode Disable or Enable radio button.
This sets the option to enable or disable the captive portal trap mode.
6. Select the Client
Authentication Failure Disable or Enable radio button.
If you enable this, the SNMP agent sends a trap when a client attempts to authenticate
with a captive portal but is unsuccessful.
7. Select the Client Connect Disable or Enable radio button.
If you enable this, the SNMP agent sends a trap when a client authenticates with, and
connects to, a captive portal.
8. Select the Client Database Full Disable or Enable radio button.
If you enable this, the SNMP agent sends a trap each time an entry cannot be added to
the client database because it is full.
9. Select the Client Disconnect Disable or Enable radio button.
If you enable this, the SNMP agent sends a trap when a client disconnects from a captive
portal.
10. Click the Apply button.
Your settings are saved.
View and Clear the Captive Portal Client
You can view and clear information about the traffic a client sent or received.
To view and clear the captive portal client:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.