User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure System Information User Manual63
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
4. Click the Login button.
The System Information page displays.
5. Select System > Management > Management Interfaces > IPv6 Management Interface
Configuration.
6. Use the Interface list to select the interface for which IPv6 parameters or management
interface can be changed.
7. When you select the Set Management Interface option, it means that the management
interface must be configured based on the interface selected. By default, this option is not
selected.
8. Select the radio button to enable or disable the Routing Mode on the management
interface.
9. Select the radio button to enable or disable the IPv6 Mode on the management interface.
10. Select the radio button to enable or disable the DHCPv6 Client Mode on the management
interface.
11. Select the radio button to enable or disable the Address Autoconfigure
Mode on the
management interface.
Note: The Address AutoConfigure Mode option is available only if Unicast
Routing is globally disabled.
12. Click the Apply button.
Your settings are saved.
In the IPv6 Default Route Configuration section of the page, the nonconfigurable IPv6
Default Route that is displayed is the default route for the IPv6 management interface.