User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure System Information User Manual64
13. To make changes, do the following:
• T
o add or remove the IPv6 default route, select the Change IPv6 Default Route
option, and specify the address value in the IPv6 Default Route Address field.
• In the Reset IPv6 Management Interface section of the page, use the Set
Management Interface to Default option to delete the port-based IPv6 management
interface configuration and set the IPv6 management interface back to the default
VLAN 1.
14. If you make any changes, click the Apply button.
Your settings are saved.
The current IPv6 Management Interface Status is displayed at the bottom of the page. The
table below describes the nonconfigurable fields.
Table 19. Current IPv6 Management Interface Status
Field Description
Management Interface Displays the current IPv6 management interface
Link State Indicates whether the link status is up or down.
IPv6 Routing Interface
Status/Operational Mode
Indicates whether the link status is up or down for the management
interface.
MAC Address The MAC address assigned to the management interface.
IP Address Configuration Method Indicates whether the IP address configuration method is DHCP or
manual.
IP Address The IP address of the management interface.
Subnet Mask The IP subnet mask for the management interface.
Gateway The specified default gateway for the management interface.