User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Monitor the Switch and Network User Manual656
8. From the Filter Type list, select the IP or MAC ACL that can mirror traffic that matches a
permit rule.
Possible values are as follows:
• None. No filter is configured for the session.
• IP ACL. Configure the IP access-list ID or name
ACL. The ID of the IP ACL to apply to
traffic from the source. Only traffic that matches the rules in the ACL is mirrored to the
destination.
• MAC ACL. Configure MAC
ACL.The ID of the MAC ACL to apply to traffic from the
source. Only traffic that matches the rules in the ACL is mirrored to the destination.
The default value is None.
9. In the Filter Name field, enter the name of the filter
, if it is configured for the session.
10. Click the Apply button.
Your settings are saved.
Configure The Port Mirroring Source Interface
Note: If an interface participates in a VLAN and is a LAG member, the VLAN
cannot be assigned as a source VLAN for a monitor session. At the
same time, if an interface participates in a VLAN and this VLAN is
assigned as a source VLAN for a monitor session, the interface can
be assigned as a LAG member.
To configure port mirroring source interface:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Monitoring > Mirroring > Multiple Port Mirroring.