User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Monitor the Switch and Network User Manual657
5. In the Source Interface Configuration section, select which interfaces are displayed on the
page:
• Select Unit ID to display the physical ports of the selected unit.
• Select LAG to display a list of LAGs only
.
• Select CPU to display a list of CPUs only
.
• Select VLANs to display a list of available VLANs.
• Select All to display a list of all physical ports, LAG, CPU, and VLANs.
6. Use one of the following methods to select an interface:
• In the Go T
o Interface field, enter the interface in the unit/slot/port format and click on
the Go button.
• Next to the Interface column, select the check box for the interface or interfaces that
you want to include.
7. In the Direction field, specify the direction of the traf
fic to be mirrored from the configured
mirrored ports.
If the value is not configured, it is shown as None. The default value is None. Direction
options are as follows:
• None.
The value is not configured.
• Tx and Rx. Monitors transmitted and received packets.
•Rx. Monitors received (ingress) packets only
.
•Tx. Monitors transmitted (egress) packets only
.
Note: For VLANs only, the Tx and Rx and None options are applicable.
• Tx and Rx. Specify VLAN as the source VLAN.
• None. Remove the specified source VLAN.