User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Monitor the Switch and Network User Manual662
8. Click the Apply button.
Your settings are saved.
Traffic of the selected interfaces is sent to the probe port.
The Status field indicates the interface status.
Configure the RSPAN Destination Switch
To configure the RSPAN destination switch:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Monitoring > Mirroring > RSP
AN Destination Switch Configuration.
5. From the Session ID list, select the session ID.
6. Select the
Admin Mode True (enabled) or False (disabled) radio button for the selected
session.
When a particular session is enabled, any traffic entering or leaving the source ports of
the session is copied (mirrored) onto the corresponding destination port or a remote
switched port analyzer (RSP
AN) VLAN. By default, the Admin mode is disabled.
7. Select the RSP
AN Source VLAN from the list of available VLAN IDs.
8. Select the RSP
AN Destination VLAN from the list of destination interfaces.
9. Configure the Filter T
ype.