User Manual

Table Of Contents
M4300 Intelligent Edge Series Fully Managed Stackable Switches
Monitor the Switch and Network User Manual668
To configure the sFlow Interface:
1. Launch a web browser.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Monitoring> sFlow >
Advanced > sFlow Interface Configuration.
5. Use one of the following methods to select an interface for the flow poller and sampler:
In the Go T
o Interface field, enter the interface in the unit/slot/port format and click on
the Go button.
Next to the Interface column, select the check box for the interface that you want to
use.
This agent supports physical ports only.
6. The Poller Receiver Index is the sFlow Receiver associated with this counter poller
.
Use Poller Receiver Index to specify the allowed range for the sFlow receiver
. The
allowed range is 1 to 8. If set to 0, the poller configuration is set to the default and the
poller is deleted.
7. Use Poller Interval to specify the maximum number of seconds between successive
samples of the counters associated with this data source.
A sampling interval of 0 disables counter sampling. The Allowed range is 0 to 86400
seconds.
8. Use Sampler Receiver Index to specify the sFlow receiver for this flow sampler.
If set to 0, the sampler configuration is set to default and the sampler is deleted. Only
active receivers can be set. If a receiver expires, then all samplers associated with the
receiver also expires.
The allowed range is 1 to 8.