User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Maintenance and Troubleshooting User Manual685
5. Use Unit to select the unit ID whose code image to activate, update, or delete.
6. Use Next
Active Image to make the selected image the next active image for subsequent
reboots of this unit.
7. Use Image Description to specify the description for the image that you selected.
8. Click the Apply button.
Your settings are saved.
Note: After activating an image, you must perform a system reset of the
switch to run the new image.
The following table describes the nonconfigurable information displayed on the page.
Troubleshooting
You can send a ping, trace a route, and perform a memory dump.
Ping an IPv4 Address
You can tell the switch to send a ping request to a specified IP address. You can check
whether the switch can communicate with a particular IP station. When you click the Apply
button, the switch sends a specified number of ping requests and the results are displayed.
Table 230. Dual Image Configuration
Field Description
Image Name This displays the image name for the selected unit.
Active Image The current active image of the selected unit.
Version The version of the image1 code file.