User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Maintenance and Troubleshooting User Manual689
11. Click the Apply button.
Pings are sent to the specified IPv6 address or host name. The switch sends the number
of pings specified in the Count field, and the results are displayed below the configurable
data in the Results area.
Send a Traceroute to an IPv4 Address
Use this page to tell the switch to send a traceroute request to a specified IP address or host
name. You can use this to discover the paths packets take to a remote destination. Once you
click the Apply button, the switch sends traceroute and the results are displayed below the
configurable data.
If a reply to the traceroute is received, the following message displays:
1 e.f.g.h 9869 usec 9775 usec 10584 usec
2 0.0.0.0 0 usec * 0 usec * 0 usec *
3 0.0.0.0 0 usec * 0 usec * 0 usec *
Hop Count = j Last TTL = k Test attempt = m Test Success = n.
To configure the traceroute settings and send probe packets to discover the route to a
host on the network:
1. Launch a web browser.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select Maintenance > T
roubleshooting > Traceroute IPv4.