User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure System Information User Manual71
3. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select System > Management > T
ime > SNTP Server Configuration.
5. In the Server T
ype list, select the address type of the configured SNTP server address.
Possible values are as follows:
• IPv4
• IPv6
• DNS
The default value is IPv4.
6. In the Address field, specify the address of the SNTP server
.
This is a text string of up to 64 characters, containing the encoded unicast IP address or
host name of an SNTP server
. Unicast SNTP requests are sent to this address. If this
address is a DNS host name, then that host name is resolved into an IP address each
time an SNTP request is sent to it.
Two SNTP servers exist by default:
• time-a.netgear
.com
• time-c.netgear
.com
7. Enter a Port number on the SNTP server to which SNTP requests are sent.
The valid range is 1 to 65535. The default value is 123.
8. Specify the Priority of this server entry in determining the sequence of servers to which
SNTP requests are sent.
The client continues sending requests to different servers until a successful response is
received, or all servers are exhausted.
The priority indicates the order in which to query
the servers. A server entry with a precedence of 1 is queried before a server with a
priority of 2, and so forth. If more than one server has the same priority, then the