User Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Configure System Information User Manual78
5. Select the Admin Mode Enable or Disable radio button.
The default is Enable.
6. Click the Apply button.
Your settings are saved.
Manage the PTP Interface Settings
On a standalone switch, by default, PTP is enabled globally on all interfaces. In a switch
stack, by default, PTP is disabled for all interfaces. You can select individual interfaces on
which you can enable or disable PTP. If you disable PTP on an interface, the interface does
not support PTP pass-through.
To configure the PTP end-to-end transparent clock settings for one or more interfaces:
1. Launch a web browser
.
2. In the address field of your web browser
, enter the IP address of the switch.
The login window opens.
3. Enter admin as the user name, enter your local device password,
and click the Login
button.
The first time that you log in, no password is required. However, you then must specify a
local device password to use each subsequent time that you log in.
The System Information page displays.
4. Select System > Management > PTP TC > Interface Configuration.