User Manual
Table Of Contents
- 8-Port and 16-Port Gigabit Ethernet Plus Click Switch
- Contents
- 1 Get Started
- 2 Network Settings
- 3 Optimize Performance With Quality of Service
- 4 Use VLANS for Traffic Segmentation
- VLAN Overview
- Create a Basic Port-Based VLAN
- Assign Ports to Multiple VLAN Groups
- Create 802.1Q-Based VLANs in a Basic Configuration
- Create 802.1Q-Based VLANs in an Advanced Configuration
- Add Tagged or Untagged Ports to an 802.1Q-Based VLAN
- Specify a Port PVID for an 802.1Q-Based VLAN
- Manage the Voice VLAN
- 5 Manage and Monitor the Switch
- Manage Flow Control
- Manage the Port Speed
- Specify a Port Description
- Enable Loop Detection
- Control the Port LEDs
- Enable the Power Saving Mode
- Change the Switch Management Mode
- Manage Access Control
- Upgrade the Firmware
- Reboot the Switch
- Save the Switch Configuration
- Restore a Saved Switch Configuration
- Restore Factory Default Settings
- Enable Port Mirroring
- View Switch Information or Change the Switch Device Name
- View Port Statistics
- 6 Manage Power over Ethernet
- 7 Diagnostics and Troubleshooting
- A Supplemental Information
8-Port and 16-Port Gigabit Ethernet Plus Click Switch
Network Settings User Manual21
Note: Model GSS108EPP provide 8 ports and can support up to 4 ports per
LAG. Model GSS116E provides 16 ports and can support up to 8 ports
per LAG.
13. For each LAG, select the ports for the LAG by selecting the associated check boxes under
the port numbers.
A LAG must consist of at least two ports. The ports that you can select depend on the
switch model:
- Model GSS108EPP. For LAG 1, you can select a combination of ports 1 through
4. For LAG 2, you can select a combination of ports 5 through 8.
- Model GSS116E. For LAG 1 and LAG 2 you can select a combination of ports 1
through 16.
14. Click the Apply button.
Your settings are saved.
15. Select System > LAG > LAG Configuration.
16. Select the ID of the LAG for which you just set up the port membership or select both LAG
IDs.
17. In the Admin Mode menu, select Enable.
18. Click the Apply button.
Your settings are saved.