User Manual
Table Of Contents
- 8-Port and 16-Port Gigabit Ethernet Plus Click Switch
- Contents
- 1 Get Started
- 2 Network Settings
- 3 Optimize Performance With Quality of Service
- 4 Use VLANS for Traffic Segmentation
- VLAN Overview
- Create a Basic Port-Based VLAN
- Assign Ports to Multiple VLAN Groups
- Create 802.1Q-Based VLANs in a Basic Configuration
- Create 802.1Q-Based VLANs in an Advanced Configuration
- Add Tagged or Untagged Ports to an 802.1Q-Based VLAN
- Specify a Port PVID for an 802.1Q-Based VLAN
- Manage the Voice VLAN
- 5 Manage and Monitor the Switch
- Manage Flow Control
- Manage the Port Speed
- Specify a Port Description
- Enable Loop Detection
- Control the Port LEDs
- Enable the Power Saving Mode
- Change the Switch Management Mode
- Manage Access Control
- Upgrade the Firmware
- Reboot the Switch
- Save the Switch Configuration
- Restore a Saved Switch Configuration
- Restore Factory Default Settings
- Enable Port Mirroring
- View Switch Information or Change the Switch Device Name
- View Port Statistics
- 6 Manage Power over Ethernet
- 7 Diagnostics and Troubleshooting
- A Supplemental Information
8-Port and 16-Port Gigabit Ethernet Plus Click Switch
Manage Power over Ethernet User Manual66
6. Select the check boxes for the PoE+ ports that you want to configure or select the check box
in the heading to configure all four PoE+ ports.
7. Configure the settings as described in the following table.
The settings that you configure apply to all selected PoE+ ports.
Menu Item Description
Port Power Select the administrative mode of the port:
• Enable.
The port’s capacity to deliver power is enabled. This is the default
setting.
• Disable.
The port’s capacity to deliver power is disabled.
Port Priority The port priority determines which ports can still deliver power after the total
power delivered by the switch exceeds the total power budget of 47W
. (In such a
situation, the switch might not be able to deliver power to all connected devices.)
If the same priority applies to two ports, the lower-numbered port receives higher
priority
.
Select one of the following priorities:
• Low. Low priority
. This is the default setting.
• High. High priority
.
• Critical. Critical priority
.
Power Mode Select the one of the following power modes:
• 802.3af.
The port is powered in and limited to the IEEE 802.3af mode. A PD
that requires IEEE 802.3at does not receive power if the port functions in
IEEE 802.3af mode.
• Legacy.
The port is powered using high-inrush current, which is used by
legacy PDs that require more than 15W to power up.
• Pre-802.3at.
The port is initially powered in the IEEE 802.3af mode and,
before 75 msec pass, is switched to the high-power IEEE 802.3at mode.
Select this mode if the PD does not perform Layer 2 classification or if switch
performs 2-event Layer 1 classification.
• 802.3at.
The port is powered in the IEEE 802.3at mode. This is the default
mode. In this mode, if the switch detects that the attached PD is not a Class
4 device, the PD does not receive power from the switch.