User Manual
Table Of Contents
- 8-Port and 16-Port Gigabit Ethernet Plus Click Switch
- Contents
- 1 Get Started
- 2 Network Settings
- 3 Optimize Performance With Quality of Service
- 4 Use VLANS for Traffic Segmentation
- VLAN Overview
- Create a Basic Port-Based VLAN
- Assign Ports to Multiple VLAN Groups
- Create 802.1Q-Based VLANs in a Basic Configuration
- Create 802.1Q-Based VLANs in an Advanced Configuration
- Add Tagged or Untagged Ports to an 802.1Q-Based VLAN
- Specify a Port PVID for an 802.1Q-Based VLAN
- Manage the Voice VLAN
- 5 Manage and Monitor the Switch
- Manage Flow Control
- Manage the Port Speed
- Specify a Port Description
- Enable Loop Detection
- Control the Port LEDs
- Enable the Power Saving Mode
- Change the Switch Management Mode
- Manage Access Control
- Upgrade the Firmware
- Reboot the Switch
- Save the Switch Configuration
- Restore a Saved Switch Configuration
- Restore Factory Default Settings
- Enable Port Mirroring
- View Switch Information or Change the Switch Device Name
- View Port Statistics
- 6 Manage Power over Ethernet
- 7 Diagnostics and Troubleshooting
- A Supplemental Information
8-Port and 16-Port Gigabit Ethernet Plus Click Switch
Supplemental Information User Manual75
Factory Default Settings
You can return the switch to its factory settings. Use the end of a paper clip or some other
similar object to press and hold the Factory Defaults button on the back panel of the switch
for at least four seconds. The switch resets and returns to the factory settings that are shown
in the following table.
Table 3. Factory default settings
Setting Value or Description
Switch name None (empty)
Switch password password
IP address 192.168.0.239
Subnet mask 255.255.255.0
DHCP mode Enabled
Port speed Auto negotiation
Flow control Disabled
Loop detection Disabled
Port LED control Link speed and activity
Power saving mode
(model GSS108EPP only)
Enabled
Switch management mode Through a web browser by accessing the local browser interface or the
ProSAFE Plus Utility
Access control
(model GSS108EPP only)
Disabled
Port mirroring Disabled
IGMP snooping • Enabled. IGMP snooping status
• Disabled. Validation of IGMPv3 IP headers
• Disabled. Blocking of unknown multicast addresses
PoE • Port Power. Enabled
• Port priority. Low
• Power mode. 802.3at
• Power limit type. User
• Power limit. 30.0W
• Detection type. IEEE 802
LAGs Disabled
Note: LAGs are supported on switch models GSS108EPP and GSS116E,
but they are not supported on switch model GSS108E.