Operation Manual

Advanced Settings

N300 Wireless Gigabit Router with USB JNR3210

To configure this mode, you have to know the MAC addresses of the child repeater access

point.

Wireless Repeater. The router sends all traffic from its local wireless or wired computers to a

remote access point. To configure this mode, you have to know the MAC address of the

remote parent access point.

The JNR3210 router is always in dual band concurrent mode, unless you turn off one radio.

Be aware that if you enable the wireless repeater in either radio band, the wireless base

station or wireless repeater cannot be enabled in the other radio band. However, if you

enable the wireless base station in either radio band and use the other radio band as a

wireless router or wireless base station, dual band concurrent mode is not affected.

For you to set up a wireless network with WDS, the following conditions have to be met for

both access points:

• Both access points have to use the same SSID, wireless channel, and encryption mode.

• Both access points have to be on the same LAN IP subnet. That is, all the access point

LAN IP addresses are in the same network.

• All LAN devices (wired and wireless computers) have to be configured to operate in the

same LAN network address range as the access points.

Wireless Repeating Function

Select Advanced > Advanced Setup > Wireless Repeating to view or change wireless

repeater settings for the router.

• Enable Wireless Repeating Function. Select the check box to use the wireless

repeating function.

• Wireless MAC of this router. This field displays the MAC address for your router for

your reference. You will need to enter this MAC address in the corresponding Wireless

Repeating Function screen of the other access point you are using.