Owner's Manual

genie Basic Settings
24
N300 Wireless Gigabit Router with USB JNR3210
If you use a wireless computer to change the wireless network name (SSID) or other wireless
security settings, you are disconnected when you click Apply. To avoid this problem, use a
computer with a wired connection to access the router.
1. On
the Basic Home screen, select Wireless to display the Wireless Settings screen.
The screen sections, settings, and procedures are explained in the following sections.
2. Make any changes tha
t are needed, and click Apply to save your settings.
3. Set up and test your
wireless devices and computers to make sure that they can connect
wirelessly. If they do not, check the following:
• Is you
r wireless device or computer connected to your network or another wireless
network in your area? Some wireless devices automatically connect to the first open
network (without wireless security) that they discover.
• Does
your wireless device or computer show up on the Attached Devices screen? If it
does, then it is connected to the network.
• If you
are not sure what the network name (SSID) or password is, look on the label on
the bottom of your router.
Wireless Settings Screen Fields
Region Selection
The location where the router is used. Select from the countries in the list. Note that in the
United States, the region is fixed to United States and is not changeable.
Wireless Network
Enable SSID Broadcast. This setting allows the router to broadcast its SSID so wireless
stations can see this wireless name (SSID) in their scanned network lists. This check box is