User Manual

Manage Device Security
350
M4100 Series Managed Switch
This field cannot be set if a redirect interface is already configured for the ACL rule. This
field is visible for a Permit action.
12. Use Redirect Interface to specify the specific egress interface where the matching traffic
stream is forced, bypassing any forwarding decision normally performed by the device.
This field cannot be set if a mirror interface is already configured for the ACL rule.
13. Use Match Every to specify an indication to match every Layer 2 MAC packet.
The valid values are as follows:
• True. Every packet must match the selected ACL rule.
• False. It is not mandatory for every packet to match the selected ACL rule.
14. Use CoS to specify the 802.1p user priority to compare against an Ethernet frame.
The valid range of values is 0 to 7.
15. Use Destination MAC to specify the destination MAC address to compare against an
Ethernet frame.
The valid format is xx:xx:xx:xx:xx:xx. The BPDU keyword can be specified using a
Destination MAC address of 01:80:C2:xx:xx:xx.
16. Use Destination MAC Mask to specify the destination MAC address mask specifying which
bits in the destination MAC to compare against an Ethernet frame.
The valid format is xx:xx:xx:xx:xx:xx. The BPDU keyword can be specified using a
destination MAC mask of 00:00:00:ff:ff:ff.
17. Use EtherType Key to specify the EtherType value to compare against an Ethernet frame.
The valid values are the following:
• Appletalk
• ARP
• IBM SNA
• IPv4
• IPv6
• IPX
• MPLS multicast
• MPLS unicast
• NetBIOS
• Novell
• PPPoE
• Reverse ARP
• User Value
18. Use EtherType User Value to specify the user-defined customized EtherType value to be
used when the user has selected User Value as the EtherType key, to compare against an
Ethernet frame.