User Manual

Configure Switching Information
254
M4200 and M4300 Series ProSAFE Managed Switches Web Management User Manual
The default is Enable.
8. In the Admin Mode list, select Enable or Disable.
This sets the port control administrative mode.For the port to participate in the network,
you must select Enable. The factory default is Enable.
9. From the LACP Mode list, select Enable or Disable.
This selects the Link Aggregation Control Protocol administrative mode. The mode must
be enabled in order for the port to participate in link aggregation. The factory default is
Enable.
10. From the Auto-negotiation list, select Enable or Disable.
This specifies the auto-negotiation mode for this port. The default is Enable.
Note: After you change the auto-negotiation mode, the switch might be
inaccessible for a number of seconds while the new settings take effect.
11. From the Speed list, select the speed value for the selected port.
Possible field values are as follows:
• Auto. All supported speeds.
• 100. 100 Mbits/second
• 10G. 10 Gbits/second.
The delimiter characters for setting different speed values are a comma (,), a period (.)
and a space ( ). For you to set the auto-negotiation speed, the auto-negotiation mode
must be set to Enable. The default is Auto.
Note: After you change the speed value, the switch might be inaccessible for
a number of seconds while the new settings take effect.
12. From the Duplex Mode list, select the duplex mode for the selected port.
Possible values are as follows:
• Auto. Indicates that speed is set by the auto-negotiation process.
• Full. Indicates that the interface supports transmission between the devices in both
directions simultaneously.
• Half. Indicates that the interface supports transmission between the devices in only
one direction at a time.
The default is Auto.
Note: After you change the duplex mode, the switch might be inaccessible for
a number of seconds while the new settings take effect.
13. Use the Link Trap object to determine whether to send a trap when link status changes.
The factory default is enabled.