User Manual

Routing
299
M4200 and M4300 Series ProSAFE Managed Switches Web Management User Manual
11. In the Admin Mode list, select to Enable or Disable IPv6 mode.
The default is Disable. When IPv6 mode is enabled, the interface is capable of IPv6
operation without a global address. In this case, an EUI-64 based link-local address is
used.
12. In the MTU field, specify the maximum transmit unit on an interface.
If the value is 0, then this interface is not enabled for routing. It is not valid to set this value
to 0 if routing is enabled. The MTU range 1280 to 1500. The default is 1500.
13. In the Duplicate Address Detection Transmits field, specify the number of duplicate
address detection (DAD) transmits on an interface.
DAD transmits values must be in the range 0 to 600. The default is 1.
14. Specify the router advertisement Life Time Interval sent from the interface.
This value must be greater than or equal to the maximum advertisement interval. 0
means do not use the router as the default router. The range of router life time is 0 to
9000. The default is 1800.
15. In the Adv NS Interval field, specify the retransmission time field of router advertisements
sent from the interface.
A value of 0 means the interval is not specified for the router. The range of the neighbor
solicit interval is 1000 to 4294967295. The default is 0.
16. In the Adv Reachable Interval field, specify the router advertisement time.
This is the amount of time allocated to consider the neighbors reachable after ND
confirmation. The range of reachable time is 0 to 3600000. The default is 0.
17. Use the Adv Interval field to specify the maximum time allowed between sending router
advertisements from the interface.
The range of the maximum advertisement interval is 4 to 1800. The default value is 600.
18. In the Adv Other Config Flag list, select Enable or Disable to specify the router
advertisement other stateful configuration flag.
Default value of other config flag is Disable.
19. In the Adv Suppress Flag list, select to Enable or Disable router advertisement
suppression on an interface.
The default value of the suppress flag is Disable.
20. In the Destination Unreachables list, select to Enable or Disable the mode of sending
ICMPv6 destination unreachables on this interface.
If disabled, then this interface does not send ICMPv6 destination unreachables. By
default, the IPv6 destination unreachables mode is enabled.
21. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.