User Manual

Configure System Information
31
M4200 and M4300 Series ProSAFE Managed Switches Web Management User Manual
6. Define the following fields:
• System Name. Enter the name to identify this switch. You can use up to 255
alphanumeric characters. The factory default is blank.
• System Location. Enter the location of this switch. You can use up to 255
alphanumeric characters. The factory default is blank.
• System Contact. Enter the contact person for this switch. You can use up to 255
alphanumeric characters. The factory default is blank.
• Login Timeout. Specify how many minutes of inactivity can occur on a serial port
connection before the switch closes the connection. Enter a number between 0 and
160 minutes. The factory default is 5. Entering 0 disables the time-out.
• Management Source Interface. Select the management interface that is used as
source interface for SNMP trap, syslog, DNS, TACACS+, RADIUS, sflow, and SNTP
applications. Possible values are as follows:
- None
- Routing Interface
- Routing VLAN
- Routing Loopback Interface
- Service Port
- Different. For some applications from the list, the source interface is configured
separately. They display in the list only if this is the case.
By default VLAN 1 is used as the source interface.
7. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
The following table describes the status information the System Information page displays.
Table 4. System Information
Field Description
Product Name The product name of this switch.
IPv4 Management Address The IPv4 address and mask assigned to the management VLAN
interface.
IPv6 Management Address The IPv6 address and mask assigned to the management VLAN
interface.
IPv4 Management Interface The IPv4 management VLAN ID of the switch. Click the displayed
Management VLAN ID value to jump to the configuration page. See
Configure an IPv4 Management VLAN on page 49.
IPv6 Management Interface The IPv6 management VLAN ID of the switch. Click the displayed
Management VLAN ID value to jump to the configuration page. See
Configure an IPv6 Management VLAN on page 51.
IPv4 Loopback Interface The IPv4 address and mask assigned to the loopback interface.