User Manual

Configure System Information
47
M4200 and M4300 Series ProSAFE Managed Switches Web Management User Manual
8. In the Subnet Mask field, specify the IP subnet mask for the interface:
• If the service port configuration protocol is None, you can manually configure a static
subnet mask.
• If the service port configuration protocol is BootP or DHCP, this field displays the
subnet mask that was dynamically acquired (if any).
9. In the Default Gateway field, specify the default gateway for the IP interface:
• If the Service Port Configuration Protocol is None, you can manually configure the IP
address of the default gateway.
• If the Service Port Configuration Protocol is BootP or DHCP, this field displays the
default gateway address that was dynamically acquired (if any).
10. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
The following table describes the nonconfigurable fields on the Service Port Configuration
page.
Configure the IPv6 Service Port
You can configure IPv6 network information on the service port. The service port is a
dedicated Ethernet port for out-of-band management of the device. Traffic on this port is
segregated from operational network traffic on the switch ports and cannot be switched or
routed to the operational network.
 To configure the IPv6 service port:
1. Launch a web browser.
2. Enter http://<ipaddress> in the web browser address field.
The login window opens.
3. Enter the user name and password.
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select System > Management > Management Interfaces > IPv6 Service Port
Configuration.
Table 15. IPv4 Service Port Configuration
Field Description
Burned-in MAC Address The burned-in MAC address used for out-of-band connectivity.
Interface Status Indicates whether the link status is up or down.