User Manual

Configure System Information
55
M4200 and M4300 Series ProSAFE Managed Switches Web Management User Manual
6. Use the Interface list to select the interface for which IPv4 parameters or management
interface can be changed.
7. When you select the Set Management Interface option, it means that the management
interface must be configured based on the interface selected.
By default, this option is not selected.
8. Select the Configuration Method DHCP or Manual radio button.
9. Specify the IP Address of the interface and the subnet mask for the management interface.
This is also referred to as the subnet/network mask, and defines the portion of the
interface’s IP address that is used to identify the attached network. The factory default
value is 169.254.100.100.
10. In the Subnet Mask field, specify the IP subnet mask for the interface.
The factory default value is 255.255.0.0.
11. In the Gateway field, specify the default gateway for the management interface.
The default value is 0.0.0.0.
Note: If you need to reset the IPv4 management interface, in the Reset IPv4
Management Interface section of the page, use the Set Management
Interface to Default option to delete the port-based IPv4
management interface configuration and set the IPv4 management
interface back to the default VLAN 1.
12. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
The Current IPv4 Management Interface Status is displayed at the bottom of the page.