User Manual

Manage Device Security
592
M4200 and M4300 Series ProSAFE Managed Switches Web Management User Manual
The System Information page displays.
5. Select Security > ACL > Basic > MAC Binding Configuration.
6. Select a MAC ACL from the ACL ID list.
You can select one and bind it to the interfaces.
The packet filtering Direction for ACL is Inbound, which means the MAC ACL rules are
applied to traffic entering the port.
7. Specify an optional Sequence Number to indicate the order of this access list relative to
other access lists already assigned to this interface and direction.
A low number indicates high precedence order. If a sequence number is already in use
for this interface and direction, the specified access list replaces the currently attached
access list using that sequence number. If you do not specify the sequence number, a
sequence number that is one greater than the highest sequence number currently in use
for this interface and direction is used. The valid range is 1–4294967295.
8. The Port Selection Table provides a list of all available valid interfaces for ACL binding. All
nonrouting physical interfaces VLAN interface and interfaces participating in LAGs are listed.
• To add the selected ACL to a port or LAG, click the box directly below the port or LAG
number so that an X appears in the box.
• To remove the selected ACL from a port or LAG, click the box directly below the port
or LAG number to clear the selection. An X in the box indicates that the ACL is
applied to the interface.
9. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.