User Manual

Manage Device Security
611
M4200 and M4300 Series ProSAFE Managed Switches Web Management User Manual
The System Information page displays.
5. Select Security > ACL > Advanced > IP Binding Configuration.
6. From the ACL ID menu, select an IP ACL.
Note: Binding ACLs to interface fails when the system has no resources to
bind a new ACL. IPv4 ACLs and IPv6 ACLs cannot be bound at the
same time to an interface.
7. Select the packet filtering Direction for ACL.
Valid directions are Inbound or Outbound. The packet filtering direction for ACL is
Inbound, which means the IP ACL rules are applied to traffic entering the port.
8. Specify an optional Sequence Number to indicate the order of this access list relative to
other access lists already assigned to this interface and direction.
A low number indicates high precedence order. If a sequence number is already in use
for this interface and direction, the specified access list replaces the currently attached
access list using that sequence number. If you do not specify the sequence number
(meaning that the value is 0), a sequence number that is one greater than the highest
sequence number currently in use for this interface and direction is used. The valid range
is 1–4294967295.
9. From the Unit 1, Unit 2, Unit 3, and LAG switch figures onscreen, select the ports and
LAGs to which the rule must apply.
If a port or LAG is not selected, click the port or LAG to select it. If a port or LAG is
selected, click the port or LAG to clear it again.
10. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.