User Manual

Configure System Information
99
M4200 and M4300 Series ProSAFE Managed Switches Web Management User Manual
• ntp. Relay network time protocol (UDP port 123) packets.
• pim-auto-rp. Relay PIM auto RP (UDP port 496) packets.
• rip. Relay Routing Image Protocol (RIP) (UDP port 520) packets
• tacacs. Relay TACACS (UDP port 49) packet
• tftp. Relay TFTP (UDP port 69) packets
• time. Relay time service (UDP port 37) packets
• Other. If this option is selected, the UDP Port Other Value is enabled. This option
permits you to enter your own UDP port in UDP Port Other Value.
9. Use UDP Port Other Value to specify a UDP Destination Port that lies between 0 and
65535.
10. Click the Add button.
An entry with the specified configuration is created in the UDP Relay Table.
11. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
The Hit Count field displays the number of UDP packets that are detected on the UDP
port.
Configure UDP Relay Interface Settings
 To configure UDP Relay Interface settings:
1. Launch a web browser.
2. Enter http://<ipaddress> in the web browser address field.
The login window opens.
3. Enter the user name and password.
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select System > Services > UDP Relay > UDP Relay Interface Configuration.
6. Use Interface to select an Interface to be enabled for the UDP Relay.