User's Manual

Smart Managed Pro Switches MS510TX and MS510TXPP
Configure Switching User Manual131
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Access the Switch on page 14.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select Switching > STP > Advanced > STP Statistics.
The STP Statistics page displays.
6. Select which type of interfaces display onscreen:
• To display physical ports only, click the PORTS link.
• To display LAGs only, click the LAGS link.
• To display both physical ports and LAGs, click the All link.
7. To refresh the page with the latest information about the switch, click the Refresh button.
The following table describes the information available about the STP Statistics page.
Configure Multicast
Multicast IP traffic is traffic that is destined to a host group. Host groups for IPv4 multicast are
identified by class D addresses, which range from 224.0.0.0 to 239.255.255.255. Host
groups for IPv6 multicast are identified by the prefix ff00::/8.
When you limit multicast transmissions to only certain ports on the switch, traffic is not
forwarded to parts of the network where it is not needed.
From the Switching > Multicast menu, you can access pages that are described in the
following sections:
• View the MFDB Table on page 132
• View the MFDB Statistics on page 133
Table 33. STP Statistics
Field Description
Interface The physical port or LAG.
STP BPDUs Received The number of STP BPDUs received at the port or LAG.
STP BPDUs Transmitted The number of STP BPDUs transmitted from the port or LAG.