User's Manual

Smart Managed Pro Switches MS510TX and MS510TXPP
Configure Quality of Service User Manual203
• VLAN. Select this check box to require a packet’s VLAN ID to match a VLAN ID or a
VLAN ID within a continuous range. If you configure a range, a match occurs if a
packet’s VLAN ID is the same as any VLAN ID within the range. The VLAN value is in
the range of 0–4093.
• Ethernet Type. Select this check box to require the EtherType value in the Ethernet
frame header to match the specified EtherType value. After you select the check box,
select the EtherType keyword from the menu of common protocols that are mapped
to their Ethertype value. If you select User Value from the menu, you can enter a
value in the field next to the menu.
• Source MAC. Select this check box to require a packet’s source MAC address to
match the specified MAC address. After you select this check box, use the following
fields to configure the source MAC address match criteria:
- Address. The source MAC address to match.
- Mask. The MAC mask, which specifies the bits in the source MAC address to
compare against the Ethernet frame. Use Fs and zeros to configure the MAC
mask. An F means that the bit is checked, and a zero in a bit position means that
the data is not significant. For example, if the MAC address is aa:bb:cc:dd:ee:ff,
and the mask is ff:ff:00:00:00:00, all MAC addresses with aa:bb:xx:xx:xx:xx result
in a match (where x is any hexadecimal number). Note that this is not a wildcard
mask, which ACLs use.
• Destination MAC. Select this check box to require a packet’s destination MAC
address to match the specified MAC address. After you select the check box, use the
following fields to configure the destination MAC address match criteria:
- Address. The destination MAC address to match.
- Mask. The MAC mask, which specifies the bits in the destination MAC address to
compare against an Ethernet frame. Use Fs and zeros to configure the MAC
mask. An F means that the bit is checked, and a zero in a bit position means that
the data is not significant. For example, if the MAC address is aa:bb:cc:dd:ee:ff,
and the mask is ff:ff:00:00:00:00, all MAC addresses with aa:bb:xx:xx:xx:xx result
in a match (where x is any hexadecimal number). Note that this is not a wildcard
mask, which ACLs use.
• Protocol Type. Select this check box to require a packet’s Layer 4 protocol to match
the specified protocol, which you must select from the menu. If you select Other from
the menu, you can enter a protocol number from 0 to 255.
• Source IP. Select this check box to require a packet’s source IP address to match the
specified IP address. After you select the check box, use the following fields to
configure the source IP address match criteria:
- Address. The source IP address format to match in dotted-decimal format.
- Mask. The bit mask in IP dotted-decimal format indicating which parts of the
source IP address to use for matching against packet content.
• Source L4 Port. Select this check box to require a packet’s TCP/UDP source port to
match the specified protocol, which you must select from the menu. If you select
Other from the menu, you can enter a source port number.