User's Manual

Smart Managed Pro Switches MS510TX and MS510TXPP
Manage Device Security User Manual221
The login window opens.
4. Enter
the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select Security
> Management Security > RADIUS > Global Configuration.
The RADIUS Configuration page displays.
The Current Server IP Address field is blank if no servers are configured (see
Configure
a RADIUS Authentication Server on the Switch on page 222). The switch supports up to
eight RADIUS servers. If more than one RADIUS server is configured,
the current server
is the server configured as the primary server. If no servers are configured as the primary
server, the current server is the most recently added RADIUS server.
6. In
the Max Number of Retransmits field, specify the maximum number of times a request
packet is retransmitted to the RADIUS server.
The valid range is from 1 to 15. The default value is 3.
Consider the maximum delay time when you are configuring RADIUS maximum
retransmit and RADIUS time-out values. See the information in the introduction of this
section.
7. In
the Timeout Duration field, specify the time-out value, in seconds, for request
retransmissions.
The valid range is from 1 to 30. The default value is 3.
Consider the maximum delay time when you are configuring RADIUS maximum
retransmit and RADIUS time-out values. See the information in the introduction of this
section.
8. From
he Accounting Mode menu, select to disable or enable RADIUS accounting on the
server.
The default is Disabled.
9. Click
the Apply button.
Your settings are saved.
The following table describes the nonconfigurable fields displayed on the page.
Table 55. RADIUS Configuration information
Field Description
Current Server Address The address of the current server. This field is blank if no servers are
configured.
Number of Configuration Servers The number of configured RADIUS servers. The value can range from
0 to 8.