User's Manual

Smart Managed Pro Switches MS510TX and MS510TXPP
Configure System Information User Manual37
9. Click the Add button.
The SNTP server entry is added.
10. Repeat
the previous steps to add additional SNTP servers.
You can configure up to eight SNTP servers.
The SNTP Server Status table displays status information about the SNTP servers
configured on your switch.
The following table describes the SNTP Server Global Status
information.
Table 7. SNTP Server Status information
Field Description
Address All the existing server addresses. If no server configuration exists, a message stating
that no SNTP server exists displays on the page.
Last Update Time The local date and time (UTC) that the response from this server was used to update
the system clock.
Change the Settings for an Existing SNTP Server
To change the settings for an existing SNTP server:
1. Connect
your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is of
f-network using an Ethernet cable.
2. Launch a web browser.
3. In
the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Access the Switch on page 14.
The login window opens.
4. Enter
the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select System
> Management > Time > SNTP Server Configuration.
The SNTP Server Configuration page displays.
6. Select
the check box for the configured server.
7. Specify
new values in the available fields.
8. Click
the Apply button.
Your settings are saved.