- Netgear Mobile Broadband Wireless-N Router Manual

Chapter 5: Advanced | 49
Mobile Broadband Wireless-N Router MBRN3000
To assign a computer or server to be a default DMZ server:
1. Go to th
e WAN Setup screen as described in the previous section.
2. Select th
e Default DMZ Server check box.
3. T
ype the IP address for that server.
4. Click App
ly to save your changes.
LAN IP Settings
The LAN IP Setup screen allows configuration of LAN IP services such as DHCP and RIP.
These features can be found under the Advanced heading in the router main menu.
The router is shipped preconfigured to use private IP addresses on the LAN side, and to act
as a DHCP server. The router default LAN IP configuration is:
• LAN IP addre
sses: 192.168.0.1
• Subnet
mask: 255.255.255.0
These addresses are part of the Internet Engineering Task Force (IETF)-designated private
a
ddress range for use in private networks, and should be suitable in most applications. If your
network has a requirement to use a different IP addressing scheme, you can make those
changes in this screen.
To view or change the LAN IP Setup:
Tip: If
you change the LAN IP address of the router while connected through
the browser, you will be disconnected and so will others connected to the
router. To connect to the router, you must open a new connection to the
new IP address and log in again. Others using the router must restart
their computers to connect to the router again.
1. Se
lect LAN IP to display the LAN Setup
screen:
2. Change the settings. For more information,
see Table 10, “DHCP Settings” o
n page 50 or
“Reserved IP Addresses” on
page 51.
3. Click App
ly to save the changes.
The LAN TCP/IP Setup parameters are
e
xplained in the following table.