- Netgear ProSafe WG102 802.11g Wireless Access Point Manual

NETGEAR ProSafe 802.11g Wireless Access Point WG102 Reference Manual
3-10 Management
v1.0, July 2008
Follow the steps below to enable Remote Management
1. Select the Enable radio button to use the SNMP remote management feature.
2. Fill in the fields according to the requirements of your location.
• Public Community Name. (Default: public) The community string to allow the SNMP
manager to read the MIB objects of the WG102.
• Private Community Name. (Default: private) The community string to allow the SNMP
manager to read and write the MIB objects of the WG102.
• Manager IP address. Enter the IP address of the SNMP manager. If this is set to
255.255.255.255, any SNMP manager will be allowed.
• IP address to Receive Traps. Enter the IP address of the SNMP manager to receive traps
sent from the wireless Access Point. If you don't want Traps to be sent, leave this at the
default value of 0.0.0.0
• Turn WEB Access Control On. Enter the IP address of the subnets that you will allow to
access this access point.
3. Be sure to click Apply to save your changes.