User manual
Table Of Contents
- Nighthawk X6 AC3200 Tri-Band WiFi Router
- Contents
- 1. Hardware Setup
- 2. Connect to the Network and Access the Router
- 3. Specify Your Internet Settings
- 4. Optimize Performance
- 5. Control Access to the Internet
- 6. Tri-Band WiFi Connections
- 7. Share USB Devices Attached to the Router
- 8. Access USB Devices Through the Internet
- 9. Use the Router as a Media Server
- 10. Share a USB Printer
- 11. Network Settings
- Set Up a Default DMZ Server
- Change the Router’s Device Name
- Change the LAN TCP/IP Settings
- Specify the IP Addresses That the Router Assigns
- Disable the DHCP Server Feature in the Router
- Reserve LAN IP Addresses
- Use the WPS Wizard for WiFi Connections
- Specify Basic WiFi Settings
- Change the WiFi Password or Security Level
- Set Up a Guest Network
- Control the Wireless Radios
- Set Up a Wireless Schedule
- Specify WPS Settings
- 12. Manage Your Network
- 13. Use VPN to Access Your Network
- 14. Specify Internet Port Settings
- 15. Troubleshooting
- Sequence to Restart Your Network
- Check Ethernet Cable Connections
- Wireless Settings
- Network Settings
- Standard LED Behavior When the Router is Powered On
- Power LED Is Off or Blinking
- Power LED Stays Amber
- LEDs Never Turn Off
- Internet or Ethernet Port LEDs Are Off
- WiFi LED Is Off
- Cannot Log In to the Router
- Cannot Access the Internet
- Changes Not Saved
- Wireless Connectivity
- Troubleshoot Your Network Using the Ping Utility
- A. Supplemental Information
Network Settings
106
Nighthawk X6 AC3200 Tri-Band WiFi Router
b. In the RIP Version list, select one of the following:
• Disabled. This is the default setting.
• RIP-1. This format is universally supported. It is adequate for most networks,
unless you have an unusual network setup.
• RIP-2. This format carries more information. Both RIP-2B and RIP-2M send the
routing data in RIP-2 format. RIP-2B uses subnet broadcasting. RIP-2M uses
multicasting.
8. Click the Apply button.
Your changes are saved.
If you changed the LAN IP address of the router, you are disconnected when this change
takes effect.
9. To reconnect, close your browser, relaunch it, and log in to the router
Specify the IP Addresses That the Router Assigns
By default, the router acts as a Dynamic Host Configuration Protocol (DHCP) server. The
router assigns IP, DNS server, and default gateway addresses to all computers connected to
the LAN. The assigned default gateway address is the LAN address of the router.
These addresses must be part of the same IP address subnet as the router’s LAN IP
address. Using the default addressing scheme, define a range between 192.168.1.2 and
192.168.1.254, although you can save part of the range for devices with fixed addresses.
To specify the pool of IP addresses that the router assigns:
1. Launch an Internet browser from a computer or wireless device that is connected to the
network.
2. Type http://www.routerlogin.net or http://www.routerlogin.com.
A login screen displays.
3. Enter the router user name and password.
The user name is admin. The default password is password. The user name and
password are case-sensitive.
The BASIC Home screen displays.