User manual
Table Of Contents
- Nighthawk X6 AC3200 Tri-Band WiFi Router
- Contents
- 1. Hardware Setup
- 2. Connect to the Network and Access the Router
- 3. Specify Your Internet Settings
- 4. Optimize Performance
- 5. Control Access to the Internet
- 6. Tri-Band WiFi Connections
- 7. Share USB Devices Attached to the Router
- 8. Access USB Devices Through the Internet
- 9. Use the Router as a Media Server
- 10. Share a USB Printer
- 11. Network Settings
- Set Up a Default DMZ Server
- Change the Router’s Device Name
- Change the LAN TCP/IP Settings
- Specify the IP Addresses That the Router Assigns
- Disable the DHCP Server Feature in the Router
- Reserve LAN IP Addresses
- Use the WPS Wizard for WiFi Connections
- Specify Basic WiFi Settings
- Change the WiFi Password or Security Level
- Set Up a Guest Network
- Control the Wireless Radios
- Set Up a Wireless Schedule
- Specify WPS Settings
- 12. Manage Your Network
- 13. Use VPN to Access Your Network
- 14. Specify Internet Port Settings
- 15. Troubleshooting
- Sequence to Restart Your Network
- Check Ethernet Cable Connections
- Wireless Settings
- Network Settings
- Standard LED Behavior When the Router is Powered On
- Power LED Is Off or Blinking
- Power LED Stays Amber
- LEDs Never Turn Off
- Internet or Ethernet Port LEDs Are Off
- WiFi LED Is Off
- Cannot Log In to the Router
- Cannot Access the Internet
- Changes Not Saved
- Wireless Connectivity
- Troubleshoot Your Network Using the Ping Utility
- A. Supplemental Information
Troubleshooting
162
Nighthawk X6 AC3200 Tri-Band WiFi Router
Quick Tips
This section describes tips for troubleshooting some common problems.
Sequence to Restart Your Network
When you need to restart your network, follow this sequence:
1. Turn off and unplug the modem.
2. Turn off the router.
3. Plug in the modem and turn it on. Wait two minutes.
4. Turn on the router and wait two minutes.
Check Ethernet Cable Connections
If your device does not power on, make sure that the Ethernet cables are securely plugged
in. The Internet LED on the router is lit if the Ethernet cable connecting the router and the
modem is plugged in securely and the modem and router are turned on. If one or more
powered-on computers are connected to the router by an Ethernet cable, the corresponding
numbered router LAN port LED lights.
Wireless Settings
Make sure that the wireless settings in the computer and router match exactly. The wireless
network name (SSID) and wireless security settings of the router and wireless computer must
match exactly.
If you set up an access list in the Advanced Wireless Settings screen, you must add each
wireless computer’s MAC address to the router’s access list.
Network Settings
Make sure that the network settings of the computer are correct. Wired and wirelessly
connected computers must use network (IP) addresses on the same network as the router.
The simplest way to do this is to configure each computer to obtain an IP address
automatically using DHCP.
Some cable modem service providers require you to use the MAC address of the computer
initially registered on the account. You can view the MAC address in the Attached Devices
screen.