Quick Start Manual

Installation Guide
ProSECURE® UTM VDSL/ADSL2+ Module
UTM VDSL/ADSL2+ Module, Annex A. Part number: NMVDSLA-10000S
UTM VDSL/ADSL2+ Module, Annex B. Part number: NMVDSLB-10000S
This guide describes how to install and remove the ProSECURE Unified Threat
Management (UTM) VDSL/ADSL2+ Module. The DSL module is intended for use in
a UTM9S or UTM25S firewall.
For information about how to configure the DSL module, see the UTM reference
manual, which you can access from the UTM web management interface or
download from the NETGEAR support site at
http://support.netgear.com.
Package Contents
• DSL module (Annex A or Annex B)
• Installation guide
DSL module
Install the DSL Module
The UMT9S and UTM25S each provide two network module slots. You can install
the DSL module in either slot. You can install only one DSL module. The other slot is
available for an optional wireless network module (NMWLSN-10000S).
To install the DSL module:
1. Turn off power to the UTM.
2. On the UTM front panel, remove one of the blank plates that cover the slots.
Save the cover plate for possible later use.
3. Insert the DSL module firmly into the slot.
Make sure that you align the sides of the DSL module with the slot guides on
each side of the slot. The following figure shows correct insertion.
4. Secure the DSL module using the two panel screws.
5. Turn on power to the UTM.
WARNING: The slot guides are not on the bottom of the slot. Do not insert the DSL
module into the bottom of the slot (you might damage the DSL module). The following
figure shows incorrect insertion.
Remove the DSL Module
To remove the DSL module:
1. Turn off power to the UTM.
2. Remove the two screws that secure the DSL module.
3. Pull the DSL module straight back from the slot.
4. Do one of the following:
• If you replace the DSL module, follow steps 3 and 4 in Install the DSL
Module.
• If you do not replace the DSL module, install a cover plate over the slot.
5. Turn on power to the UTM.