User's Manual

Firewall Protection
146
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Unless your selection from the Action drop-down list is BLOCK always, you also need to
make selections from the following drop-down lists:
• Select Sch
edule
• Qo
S Priority
• NA
T IP (This drop-down list is available only when the WAN mode is NAT. If you
select Single Address, the IP address specified should fall under the WAN subnet.)
4. Click Apply. The new rule is
now added to the Outbound Services table. The rule is
automatically enabled.
IPv6 DMZ WAN Outbound Service Rules
 To create a new IPv6 DMZ WAN outbound rule:
1. In
the upper right of the DMZ WAN Rules screen, select the IPv6 radio button. The screen
displays the IPv6 settings (see Figure 68 on
page 144).
2. Click the Add t
able button under the Outbound Services table. The Add DMZ WAN
Outbound Service screen for IPv6 displays:
Figure 70.
3. Enter the settings as explained in Table 32 on page 128. In addition to selections from the
Service, Action, and Log drop-down lists, you need to make selections from the following
drop-do
wn lists:
• DMZ Users
• WA
N Users