Installation Guide

Installation Guide
Installation
To install and set up the Push 2 TV adapter:
1. Connect the Push 2 TV adapter to your TV and plug in the power cord.
The Push 2 TV adapter LED is red when it powers up. Then the LED turns
yellow to indicate it is ready, but is not yet connected to your computer.
2. Turn on your TV and select the correct TV input source for your TV.
• If you are not sure which input source should be used, check the
documentation that came with your TV set.
• The Ready for Connection screen displays on your TV within 30 seconds.
If you do not see this screen, make sure the TV input is set to the port where the
Push 2 TV adapter is connected and all cable connections are firmly secured.
3. On your laptop, launch the Intel Wireless Display software. There are two ways
to do this:
• If your laptop has a button or key, press it.
• From Windows select Start. Type Intel Wireless Display in the search field.
Select and run the Intel Wireless Display software.
4. Use the Intel Wireless Display software to scan and find the Push 2 TV
adapter.
The screen on the right shows that the
Intel Wireless Display software has found
the wireless adapter.
5. Double-click the Push 2 TV adapter to
connect to it. The LED on the Push 2 TV
adapter starts flashing green.
6. If you are connecting the laptop to the
Push 2 TV adapter for the first time, the
Push 2 TV adapter displays a 4-digit
security code on the TV. Enter this 4-digit
security code into the Intel Wireless
Display software.
7. Within a few seconds the TV screen will display your laptop screen. The LED
on the Push 2 TV adapter turns solid green.
You are now ready to use Push 2 TV/Intel Wireless Display.
Push 2 TV Adapter (PTV1000)/Intel® Wireless Display
Package Contents
Push 2 TV Front and Back Views
HDMI cable
Push 2 TV adapter
Power cord
HDMI
LED
Power On/Off Composite Reset