Use and Care Manual

Overview

Orbi WiFi System

Optional Orbi Add-On Satellite LEDs

You can purchase add-on Orbi satellites (sold separately) and add them to your Orbi

network.

Table 2. Orbi add-on satellite LED description

LED LED Behavior

Power LED The Power LED is located above the Power On/Off button on the rear

panel. Note:

The wall plug satellite does not include a Power LED.

• Solid green. Power is on.

• Solid amber. The

satellite is rebooting.

• Blinking amber.

The satellite is resetting to factory default settings.

• Blinking red. The

firmware is corrupted.

• Off. Power is not supplied.

Add-on satellite ring LED Optional add-on satellites are sold separately and can be added to your

Orbi network.

The ring LED is located on the top.

• Pulsing white. The

satellite is booting.

• Solid white.

The satellite is ready to sync to the router (press the Sync

button).

• Blue for three minutes. The

connection between the satellite and the

router is good.

• Amber for three minutes. The

connection between the satellite and

the router is fair.

• Magenta.

The satellite is not connected to the router or is not getting an

IP address.

• Off.

The satellite synced to the router and is working normally.

Connect Your Router

 To cable your router:

1. Unplug your modem’

s power, leaving the modem connected to the wall jack for your

Internet service.

If your modem uses a battery backup, remove the battery.

2. Plug in and turn on your modem.

If your modem uses a battery backup, put the battery back in.