User Manual

Optimize Performance

Orbi High-Performance AC3000 Tri-band WiFi System

 To enable Universal Plug and Play:

1. Launch a web browser from a computer or mobile device that is connected to the

network.

2. Enter orbilogin.com.

A login window opens.

3. Enter the router user name and password.

The user name is admin. The default password is password. The user name and

password are case-sensitive.

The BASIC Home page displays.

4. Select ADVANCED > Advanced Setup > UPnP.

The UPnP page displays.

5. Select the Turn UPnP On check box.

By default, this check box is selected. UPnP for automatic device configuration can be

enabled or disabled. If the Turn UPnP On check box is cleared, the router does not allow

any device to automatically control router resources, such as port forwarding.

6. Type the advertisement period in minutes.

The advertisement period specifies how often the router broadcasts its UPnP information.

This value can range from 1 to 1440 minutes. The default period is 30 minutes. Shorter

durations ensure that control points receive current device status at the expense of more

network traffic. Longer durations can compromise the freshness of the device status but

can significantly reduce network traffic.

7. Type the advertisement time to live in hops.

The time to live for the advertisement is measured in hops (steps) for each UPnP packet

sent. Hops are the steps a packet takes between routers. The number of hops can range

from 1 to 255. The default value for the advertisement time to live is 4 hops, which should

be fine for most home networks. If you notice that some devices are not being updated or

reached correctly, it might be necessary to increase this value.

8. Click the Apply button.

The UPnP Portmap Table displays the IP address of each UPnP device that is accessing

the router and which ports (internal and external) that device opened. The UPnP Portmap

Table also displays what type of port is open and whether that port is still active for each

IP address.

9. To refresh the information in the UPnP Portmap Table, click the Refresh button.