User Manual
Table Of Contents
- Contents
- 1. Getting Started
- Start Using Your ReadyNAS System
- Additional Documentation
- Supported ReadyNAS Systems
- Supported Operating Systems
- Supported Browsers
- Diskless Systems
- Basic Installation
- Upgrade Pre-6.2 ReadyNAS Firmware for Use With ReadyCLOUD
- Discover and Set Up Your ReadyNAS Using ReadyCLOUD
- Local Setup Wizard
- Admin Page
- Access the Local Admin Page
- Register Your System
- Five Levels of Protection
- The ReadyNAS Community
- Safe Mode
- 2. Volume Configuration
- Basic Volume and RAID Concepts
- ReadyTIER, Tiers, Data, and Metadata
- Manage Volumes
- Change RAID Mode
- View the Status of a Volume
- Configure the Checksum Function
- Format Disks
- Create and Encrypt a Volume
- Delete a Volume
- Name a USB Drive
- Expand Storage Capacity
- Add Protection to a Volume
- Add Protection to a Flex-RAID Volume
- Add a Group to a Flex-RAID Volume
- Delete a RAID Group
- Use the Volume Management Wizard to Create a Volume
- Add a Tier to a Volume
- Enable or Disable Quotas on Volumes
- Maintain Volumes
- 3. Shares
- 4. LUNs
- 5. Snapshots
- 6. Users and Groups
- 7. Use Cloud Services
- 8. System Settings
- 9. System Power
- 10. Install and Manage Apps
- 11. System Monitoring
- 12. System Maintenance
- 13. Backup and Recovery
6. In the Teaming Mode menu, select a teaming mode.
For more information about teaming modes, see Teaming Modes on page 196.
7. (For IEEE 802.3ad LACP and XOR only) Select the radio button next to the hash type
option that you want to use. For more information about hash types, see Hash Types
on page 197.
8. (For Active Backup only) In the Primary Device menu, select the Ethernet interface
that is active by default.
Other Ethernet interfaces in the bond become active if and only if the active interface
fails.
9. Click the Create button.
The new bonded adapter displays on the Network page. The bonded adapter is
named bondX, where X is a number in sequential and ascending order.
Configure General and TCP/IP Settings
To configure a bonded adapter:
1. Log in to your ReadyNAS.
2. Select Network > Bonds.
The page updates showing the bonded interfaces.
3. Click the gear icon for the bonded adapter.
4. Click the Settings button in the pop-up menu.
The bond settings pop-up window opens.
5. Configure the settings in the General tab as explained in the following table:
DescriptionItem
Cannot be edited. Displays the name of the bonded
adapter.
Name
Enter the MTU in bytes. The default setting is 1500
bytes.
MTU
6. Click the IPv4 tab.
7. Configure the IPv4 settings as explained in the following table.
Software Manual199System Settings
ReadyNAS OS 6.10