User Manual
Table Of Contents
- Contents
- 1. Getting Started
- Start Using Your ReadyNAS System
- Additional Documentation
- Supported ReadyNAS Systems
- Supported Operating Systems
- Supported Browsers
- Diskless Systems
- Basic Installation
- Upgrade Pre-6.2 ReadyNAS Firmware for Use With ReadyCLOUD
- Discover and Set Up Your ReadyNAS Using ReadyCLOUD
- Local Setup Wizard
- Admin Page
- Access the Local Admin Page
- Register Your System
- Five Levels of Protection
- The ReadyNAS Community
- Safe Mode
- 2. Volume Configuration
- Basic Volume and RAID Concepts
- ReadyTIER, Tiers, Data, and Metadata
- Manage Volumes
- Change RAID Mode
- View the Status of a Volume
- Configure the Checksum Function
- Format Disks
- Create and Encrypt a Volume
- Delete a Volume
- Name a USB Drive
- Expand Storage Capacity
- Add Protection to a Volume
- Add Protection to a Flex-RAID Volume
- Add a Group to a Flex-RAID Volume
- Delete a RAID Group
- Use the Volume Management Wizard to Create a Volume
- Add a Tier to a Volume
- Enable or Disable Quotas on Volumes
- Maintain Volumes
- 3. Shares
- 4. LUNs
- 5. Snapshots
- 6. Users and Groups
- 7. Use Cloud Services
- 8. System Settings
- 9. System Power
- 10. Install and Manage Apps
- 11. System Monitoring
- 12. System Maintenance
- 13. Backup and Recovery
5. Click the + button ( ) to the right of the list of initiators.
6. In the Name field, enter an IQN in the format as defined by RFC 3720, for example,
iqn.2012-04.com.netgear:sj-tst-5200:a123b456 is a valid IQN.
7. (Optional) Enter a CHAP password that is between 12 and 16 characters long and
confirm the CHAP password.
8. Click the Create button.
9. Select the Allowed check box to allow the initiator access to the LUN group.
10. Click the Apply button.
The new LUN group properties take effect immediately.
Software Manual110LUNs
ReadyNAS OS 6.10