User Manual
Table Of Contents
- Contents
- 1. Getting Started
- Start Using Your ReadyNAS System
- Additional Documentation
- Supported ReadyNAS Systems
- Supported Operating Systems
- Supported Browsers
- Diskless Systems
- Basic Installation
- Upgrade Pre-6.2 ReadyNAS Firmware for Use With ReadyCLOUD
- Discover and Set Up Your ReadyNAS Using ReadyCLOUD
- Local Setup Wizard
- Admin Page
- Access the Local Admin Page
- Register Your System
- Five Levels of Protection
- The ReadyNAS Community
- Safe Mode
- 2. Volume Configuration
- Basic Volume and RAID Concepts
- ReadyTIER, Tiers, Data, and Metadata
- Manage Volumes
- Change RAID Mode
- View the Status of a Volume
- Configure the Checksum Function
- Format Disks
- Create and Encrypt a Volume
- Delete a Volume
- Name a USB Drive
- Expand Storage Capacity
- Add Protection to a Volume
- Add Protection to a Flex-RAID Volume
- Add a Group to a Flex-RAID Volume
- Delete a RAID Group
- Use the Volume Management Wizard to Create a Volume
- Add a Tier to a Volume
- Enable or Disable Quotas on Volumes
- Maintain Volumes
- 3. Shares
- 4. LUNs
- 5. Snapshots
- 6. Users and Groups
- 7. Use Cloud Services
- 8. System Settings
- 9. System Power
- 10. Install and Manage Apps
- 11. System Monitoring
- 12. System Maintenance
- 13. Backup and Recovery
Network
The Network throughput graph shows the network usage for Tx and Rx traffic in bytes
per second.
The range is flexible and depends on your selections from the menus above the graph.
For example, the range can be 0 to 60 bytes or from 0 to 40 KB. The upper part of the
graph indicates the incoming (Rx) traffic; the lower part of the graph indicates the
outgoing (Tx) traffic.
From the menus above the graph, you can adjust the following settings:
•
Network. Select all network interfaces, individual interfaces, or individual bonds.
•
Protocol. Select all protocols or individual protocols (SMB, NFS, AFP, HTTP, HTTPS,
SSH, iSCSI, or SMTP).
•
Period. Select the period over which the network usage is measured. You can select
from 5 minutes to 1 year.
•
Update. Select how often the information in the table is updated. You can select
from 1 to 30 minutes.
Utilization
The Volume utilization graph shows the percentage of used storage space for an
individual volume or for all volumes. The range is from 0 to 100 percent.
Software Manual243System Monitoring
ReadyNAS OS 6.10