User Manual
Table Of Contents
- Contents
- 1. Getting Started
- Start Using Your ReadyNAS System
- Additional Documentation
- Supported ReadyNAS Systems
- Supported Operating Systems
- Supported Browsers
- Diskless Systems
- Basic Installation
- Upgrade Pre-6.2 ReadyNAS Firmware for Use With ReadyCLOUD
- Discover and Set Up Your ReadyNAS Using ReadyCLOUD
- Local Setup Wizard
- Admin Page
- Access the Local Admin Page
- Register Your System
- Five Levels of Protection
- The ReadyNAS Community
- Safe Mode
- 2. Volume Configuration
- Basic Volume and RAID Concepts
- ReadyTIER, Tiers, Data, and Metadata
- Manage Volumes
- Change RAID Mode
- View the Status of a Volume
- Configure the Checksum Function
- Format Disks
- Create and Encrypt a Volume
- Delete a Volume
- Name a USB Drive
- Expand Storage Capacity
- Add Protection to a Volume
- Add Protection to a Flex-RAID Volume
- Add a Group to a Flex-RAID Volume
- Delete a RAID Group
- Use the Volume Management Wizard to Create a Volume
- Add a Tier to a Volume
- Enable or Disable Quotas on Volumes
- Maintain Volumes
- 3. Shares
- 4. LUNs
- 5. Snapshots
- 6. Users and Groups
- 7. Use Cloud Services
- 8. System Settings
- 9. System Power
- 10. Install and Manage Apps
- 11. System Monitoring
- 12. System Maintenance
- 13. Backup and Recovery
3. Click the SNMP button.
4. Configure the settings as explained in the following table:
DescriptionItem
Select the check box to enable SNMP globally. Clear the check box to disable SNMP
globally.
Enable SNMP
Enter the community. Normally, you would enter public for a read-only community
and private for a read/write community. You can leave the Community field set to
public (which is the default setting) or you can specify a private name if you use a
more segregated monitoring scheme.
Community
Enter the IP address to which the ReadyNAS sends the traps that it generates. For
information about the types of messages that the ReadyNAS sends, see System Logs,
Auditing, and Active Connections on page 245.
Trap Destination
Enter a network address that specifies the hosts that are allowed to access the
ReadyNAS.
Hosts Allowed Access
5. Click the Apply button.
Your settings are saved.
Download the NETGEAR SNMP MIB
You can download the NETGEAR SNMP MIB from the Admin Page and import it to your
SNMP client applications. For information about the types of messages that the
ReadyNAS can send to SNMP hosts, see System Logs, Auditing, and Active Connections
on page 245.
Software Manual251System Monitoring
ReadyNAS OS 6.10