User Manual
Table Of Contents
- Contents
- 1. Getting Started
- Start Using Your ReadyNAS System
- Additional Documentation
- Supported ReadyNAS Systems
- Supported Operating Systems
- Supported Browsers
- Diskless Systems
- Basic Installation
- Upgrade Pre-6.2 ReadyNAS Firmware for Use With ReadyCLOUD
- Discover and Set Up Your ReadyNAS Using ReadyCLOUD
- Local Setup Wizard
- Admin Page
- Access the Local Admin Page
- Register Your System
- Five Levels of Protection
- The ReadyNAS Community
- Safe Mode
- 2. Volume Configuration
- Basic Volume and RAID Concepts
- ReadyTIER, Tiers, Data, and Metadata
- Manage Volumes
- Change RAID Mode
- View the Status of a Volume
- Configure the Checksum Function
- Format Disks
- Create and Encrypt a Volume
- Delete a Volume
- Name a USB Drive
- Expand Storage Capacity
- Add Protection to a Volume
- Add Protection to a Flex-RAID Volume
- Add a Group to a Flex-RAID Volume
- Delete a RAID Group
- Use the Volume Management Wizard to Create a Volume
- Add a Tier to a Volume
- Enable or Disable Quotas on Volumes
- Maintain Volumes
- 3. Shares
- 4. LUNs
- 5. Snapshots
- 6. Users and Groups
- 7. Use Cloud Services
- 8. System Settings
- 9. System Power
- 10. Install and Manage Apps
- 11. System Monitoring
- 12. System Maintenance
- 13. Backup and Recovery
-
If you select the Rsync server protocol, specify the module name followed by
the path, for example:
<module name>/path
WARNING: Backing up using the Rsync protocol is for expert users only.
-
If you select the Rsync over Remote SSH protocol, specify the relative or
absolute path, for example:
- <relative path>
- /<absolute path>
WARNING: During backup using the Rsync over Remote SSH protocol,
specifying an absolute path might overwrite existing files at that destination.
Backing up using the Rsync over Remote SSH protocol is for expert users only.
- Do not use a backslash (\) in paths.
Note: If you configured a remote source, you can immediately test the connection
by selecting the Test Connection button.
7. From the pair of buttons on the right side of the window, click the Local button to
store the backup locally (on the ReadyNAS, or connected USB drive, or connected
eSATA drive), or click the Remote button.
Note: The source and destination of the job cannot both be remote.
The window adjusts to show the appropriate set of parameters.
8. Do one of the following:
•
If you clicked the Local button, click the Browse button and navigate to the
destination folder.
•
If you clicked the Remote button, enter the host name, select the backup protocol,
the path, and if required, the login ID and password.
Enter the folder path according to the following:
-
If you select a Windows protocol, use a forward slash (/) to separate directories,
for example, enter the following:
/<share name>/<folder name>
Software Manual272Backup and Recovery
ReadyNAS OS 6.10