User Manual
Table Of Contents
- Contents
- 1. Getting Started
- Start Using Your ReadyNAS System
- Additional Documentation
- Supported ReadyNAS Systems
- Supported Operating Systems
- Supported Browsers
- Diskless Systems
- Basic Installation
- Upgrade Pre-6.2 ReadyNAS Firmware for Use With ReadyCLOUD
- Discover and Set Up Your ReadyNAS Using ReadyCLOUD
- Local Setup Wizard
- Admin Page
- Access the Local Admin Page
- Register Your System
- Five Levels of Protection
- The ReadyNAS Community
- Safe Mode
- 2. Volume Configuration
- Basic Volume and RAID Concepts
- ReadyTIER, Tiers, Data, and Metadata
- Manage Volumes
- Change RAID Mode
- View the Status of a Volume
- Configure the Checksum Function
- Format Disks
- Create and Encrypt a Volume
- Delete a Volume
- Name a USB Drive
- Expand Storage Capacity
- Add Protection to a Volume
- Add Protection to a Flex-RAID Volume
- Add a Group to a Flex-RAID Volume
- Delete a RAID Group
- Use the Volume Management Wizard to Create a Volume
- Add a Tier to a Volume
- Enable or Disable Quotas on Volumes
- Maintain Volumes
- 3. Shares
- 4. LUNs
- 5. Snapshots
- 6. Users and Groups
- 7. Use Cloud Services
- 8. System Settings
- 9. System Power
- 10. Install and Manage Apps
- 11. System Monitoring
- 12. System Maintenance
- 13. Backup and Recovery
12. Adjust the maximum bandwidth used for the transfer, if desired.
If the network connection between the source and destination systems is fast, the
transfer could slow either or both of the devices. This is very likely if the source and
destination are both local. Zero, the default, sets no limit to the bandwidth.
13. To seed the job, click the Export seed for this job box.
Note: Clicking the Export seed for this job box disables the job. After you transfer
the seed archive file, start the job by selecting Backup > ReadyDR, selecting the
job, clicking the gear icon, and selecting the Enable menu item. For information
about transfering job seed archive files, see Seed a ReadyDR Job on page 292.
14. Click the Finish button.
The window closes and the new job is added to the Jobs list.
Monitor and Change ReadyDR Jobs
You can manually start a job, view the job history, export a seed file, delete the job,
enable a stopped job, and change the job settings.
To check the history or change job parameters:
1. Log in to your ReadyNAS.
2. Select Backup.
3.
Select the ReadyDR job you want to monitor or change from the ReadyDR section.
4. Click the gear icon.
The options menu opens.
5. Click the desired action.
Immediately runs the job.Start
Displays the job history.History
Creates a file archive of the share or LUN and opens a file
browse window where you select the destination. The file name
Export
follows the format ReadyDR_Seed-.jobnamehostname Use
this file to seed a new ReadyDR job.
Deletes the job.Delete
Enables a stopped job.Enable
Disables the job.Disable
Opens the settings window for the job. From this window you
can change the schedule, and the Bandwidth Limit,
Compression, and Encrypted Transport options.
Settings
Software Manual295Backup and Recovery
ReadyNAS OS 6.10