User Manual
Table Of Contents
- Contents
- 1. Getting Started
- Start Using Your ReadyNAS System
- Additional Documentation
- Supported ReadyNAS Systems
- Supported Operating Systems
- Supported Browsers
- Diskless Systems
- Basic Installation
- Upgrade Pre-6.2 ReadyNAS Firmware for Use With ReadyCLOUD
- Discover and Set Up Your ReadyNAS Using ReadyCLOUD
- Local Setup Wizard
- Admin Page
- Access the Local Admin Page
- Register Your System
- Five Levels of Protection
- The ReadyNAS Community
- Safe Mode
- 2. Volume Configuration
- Basic Volume and RAID Concepts
- ReadyTIER, Tiers, Data, and Metadata
- Manage Volumes
- Change RAID Mode
- View the Status of a Volume
- Configure the Checksum Function
- Format Disks
- Create and Encrypt a Volume
- Delete a Volume
- Name a USB Drive
- Expand Storage Capacity
- Add Protection to a Volume
- Add Protection to a Flex-RAID Volume
- Add a Group to a Flex-RAID Volume
- Delete a RAID Group
- Use the Volume Management Wizard to Create a Volume
- Add a Tier to a Volume
- Enable or Disable Quotas on Volumes
- Maintain Volumes
- 3. Shares
- 4. LUNs
- 5. Snapshots
- 6. Users and Groups
- 7. Use Cloud Services
- 8. System Settings
- 9. System Power
- 10. Install and Manage Apps
- 11. System Monitoring
- 12. System Maintenance
- 13. Backup and Recovery
The page adjusts to display the access properties for the selected protocol.
8. Configure the network access settings for the selected protocol.
For more information, see the following sections (not all sections apply to all
protocols):
•
Configure User and Group Settings on page 72.
•
Configure Host Settings on page 75.
•
Configure Rsync Credentials on page 77.
•
Manage Access to Remote Shared Folders on page 78.
•
Hide a Shared Folder on page 80.
9. Set the On-Off slider for the selected protocol:
•
To enable the protocol for the selected folder, set the On-Off slider so that the
slider shows the On position.
The indicator on the protocol button turns green.
Note: When you enable a file-sharing protocol for an individual share, the
protocol is also enabled globally. For more information about global settings,
see Configure Global Settings for File-Sharing Protocols on page 206.
•
To save the configured access settings but prevent them from taking effect, set
the On-Off slider so that the slider shows the Off position.
The indicator on the protocol button turns gray.
Note: When you disable a file-sharing protocol for an individual share, the
protocol remains enabled globally so that you can still access other folders that
might be using the protocol. For more information about global settings, see
Configure Global Settings for File-Sharing Protocols on page 206.
10. Click the Apply button.
11. Click the OK button.
Your changes are saved and the pop-up window closes.
Configure User and Group Settings
For SMB, AFP, FTP, and HTTP, you can configure access rights to an individual share
for users and groups. User and group settings do not apply to NFS and Rsync.
Note: You cannot configure access rights for the ReadyNAS admin ( ) or for Cloud
users ( ). For more information about Cloud users, see Use Cloud Services on page
152.
Software Manual72Shares
ReadyNAS OS 6.10