Specifications

Introduction
16
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Rear Panel
The rear panel of the VPN firewall includes a console port, a reset button, a cable lock
receptacle, an AC power connection, and a power switch.
Figure 2.
Viewed from left to right, the rear panel contains the following components:
1. Cable security lock receptacle.
2. Console port. Port for connecting to an optional console terminal. The ports has a DB9 male
connector. The default baud rate is 9600 K. The pinouts are: (2) Tx, (3) Rx, (5) and (7) Gnd.
For information about accessing the command line interface (CLI) using the console port,
see Using the Command-Line Interface on page 253.
3. Factory default reset button. Using a sharp object, press and hold this button for about eight
seconds until the front panel Test light flashes to reset the VPN firewall to factory default
settings. All configuration settings are lost, and the default password is restored.
4. AC power receptacle. Universal AC input (100–240 VAC, 50–60 Hz).
5. A power on/off switch.
WAN Ports
Left LED On (green) The WAN port has a valid connection with a device that provides an
Internet connection.
Blinking (green) Data is being transmitted or received by the WAN port.
Off The WAN port has no physical link, that is, no Ethernet cable is
plugged into the VPN firewall.
Right LED On (green) The WAN port is operating at 1000 Mbps.
On (amber) The WAN port is operating at 100 Mbps.
Off The WAN port is operating at 10 Mbps.
Internet LED On (green) The WAN port has a valid Internet connection.
Off The WAN port is either not enabled or has no link to the Internet.
Table 1. LED descriptions (continued)
LED Activity Description
Security lock
receptacle
Console port
Reset button
AC power
receptacle
Power
Switch