Specifications

Virtual Private Networking Using IPSec Connections
167
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Each policy contains the data that are explained in the following table. These fields are
explained in more detail in Table 40 on page 169.
 To delete one or more VPN polices:
1. Select the check box to the left of the policy that you want to delete, or click the Select
All table button to select all VPN policies.
2. Click the Delete table button.
 To enable or disable one ore more VPN policies:
1. Select the check box to the left of the policy that you want to delete, or click the Select
All table button to select all IKE Policies.
2. Click the Enable or Disable table button.
For information about how to add or edit a VPN policy, see the next section, Manually Add or
Edit a VPN Policy.
Note: You cannot delete or edit an IKE policy for which the VPN policy is
active. You first need to disable or delete the VPN policy before you
can delete or edit the IKE policy.
Table 39. VPN Policies screen information
Item Description
! (Status) Indicates whether the policy is enabled (green circle) or disabled (gray circle). To enable
or disable a policy, select the check box adjacent to the circle and click the Enable or
Disable table button, as appropriate.
Name The name that identifies the VPN policy. When you use the VPN Wizard to create a VPN
policy, the name of the VPN policy (and of the automatically created accompanying IKE
policy) is the connection name.
Type Auto or Manual as described previously (Auto is used during VPN Wizard configuration).
Local IP address (either a single address, range of addresses, or subnet address) on your
LAN. Traffic needs to be from (or to) these addresses to be covered by this policy. (The
subnet address is supplied as the default IP address when you are using the VPN
Wizard).
Remote IP address or address range of the remote network. Traffic needs to be to (or from) these
addresses to be covered by this policy. (The VPN Wizard default requires the remote
LAN IP address and subnet mask.)
Auth The authentication algorithm that is used for the VPN tunnel. This setting needs to match
the setting on the remote endpoint.
Encr The encryption algorithm that is used for the VPN tunnel. This setting needs to match the
setting on the remote endpoint.