Specifications

Virtual Private Networking Using IPSec Connections
188
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
The IPSec pane displays in the Configuration Panel screen, with the IPSec tab selected
by default.
Figure 116.
3. Specify the settings that are explained in the following table.
Table 47. VPN client IPSec configuration settings (Mode Config)
Setting Description
VPN Client address This field is masked out because Mode Config is selected. After an IPSec
connection is established, the IP address that is issued by the VPN firewall displays
in this field (see Figure 121 on page 192).
Address Type Select Subnet address from the drop-down list.
Remote host address The address that you need to enter depends on whether or not you have specified a
LAN IP network address in the Local IP Address field on the Add Mode Config
Record screen of the VPN firewall:
• If you left the Local IP Address field blank, enter the VPN firewall’s default LAN IP
address as the remote host address that opens the VPN tunnel. For example,
enter 192.168.1.1.
• If you specified a LAN IP network address in the Local IP Address field, enter the
address that you specified as the remote host address that opens the VPN
tunnel.
Subnet Mask Enter 255.255.255.0 as the remote subnet mask of the VPN firewall that opens the
VPN tunnel. This is the LAN IP subnet mask that you specified in the Local Subnet
Mask field on the Add Mode Config Record screen of the VPN firewall. If you left the
Local Subnet Mask field blank, enter the VPN firewall’s default IP subnet mask.