Specifications

Troubleshooting and Using Online Support
300
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Figure 181.
The VPN firewall reboots. During the reboot process, the Settings Backup and Firmware
Upgrade screen might remain visible. The reboot process is complete after several minutes
when the Test LED on the front panel goes off.
WARNING!
When you push the hardware reset button or click the software
Default button, the VPN firewall settings are erased. All firewall
rules, VPN policies, LAN/WAN settings, and other settings are lost.
Back up your settings if you intend on using them.
Note: After rebooting with factory default settings, the VPN firewall’s
password is password, and the LAN IP address is 192.168.1.1.
Problems with Date and Time
The Time Zone screen displays the current date and time of day (see Configure Date and
Time Service on page 260). The VPN firewall uses the Network Time Protocol (NTP) to
obtain the current time from one of several network time servers on the Internet. Each entry in
the log is stamped with the date and time of day.
Problems with the date and time function can include:
• Date shown is January 1, 2000. Cause: The VPN firewall has not yet successfully
reached a network time server. Check that your Internet access settings are configured
correctly. If you have just completed configuring the VPN firewall, wait at least 5 minutes
and check the date and time again.