Manual Unihan UPWL6031H5
1.General Description The UPWL6031H5 wireless module is a fully assembled and tested general-purpose module using the BCM4331wireless System-on-Chip(SoC). The module contains BCM4331 chip and all other necessary components to operate the UPWL6031H5. For detailed information on the UPWL6031H5 component itself, refer to the UPWL6031H5 datasheet. 2. Features Features Description Network Standard IEEE 802.11 b/g/n (final n) Chipset BCM4331 Input Voltage 3.3V,5V Data Rate 802.
. Benefits Small, self-contained SMT module. 3X3 MIMO function support High power solution support high speed transmittance For product available in the USA/Canada market, only CH36~CH48,CH149~CH165 can be operated. Selection of other channels is not possible. Federal Communications Commission Statement This device complies with FCC Rules Part 15. Operation is subject to the following i. This device may not cause harmful interference, and ii.
i. Reorient or relocate the receiving antenna. ii. Increase the separation between the equipment and receiver. iii. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. iv. Consult the dealer or an experienced radio/TV technician for help. This device is going to be operated in 5.15~5.25GHz frequency range, it is restricted in indoor environment only.
Safety statements Regulatory Information/Disclaimers Installation and use of this Bluetooth device must be in strict accordance with the instructions included in the user documentation provided with the product. Any changes or modifications (including the antennas) made to this device that are not expressly approved by the manufacturer may void the user’s authority to operate the equipment.
When using this device, a certain separation distance between antenna and nearby persons has to be kept to ensure RF exposure compliance. In order to comply with the RF exposure limits established in the ANSI C95.1 standards, the distance between the antennas and the user should not be less than [20cm]. RF Exposure The antenna(s) used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Step 2
Step 3
Step 4
Step 5
